Looking for a 1" (or greater) 1D CCD with ~ 9-10 um pixels.

[Sutherland, Scott]

Posted to CCD-world:
-+-+-+-
Hello all:

I am looking for a CCD chip that is at least 25.4 mm in length
and has 9-10 um pixels by 200 um height minimum.  It should
be a 1-D array with good QE, sensitivity, low noise, and relatively
low dark current.  The specs for the current chip I am using are:

SONY ILX511
Temp:			25 deg C
Clock Frequency:	1 MHz
Light Source:		3200 K
IR Cut Filter:		CM-500S (t = 1.0 mm)

QUESTION:  	Are these tests done with an IR cutoff filter??  QE curves
too??
		That could explain a lot.

QE:		Peaks at ~450 nm (absolute value unknown).
Sensitivity:	200 V/(lx*s), uniform intensity illumination
		1800 V/(lx*s)	LED at 660 nm

Dark Voltage:	3.0 mV (10 msec integration, 25 deg C)
Saturation
Output Voltage:	800 mV
Saturation
Exposure:	0.004 lx*s (for white light exposure)


Any suggestions would be appreciated.

Dr. Scott Sutherland
Senior Scientist
GAMMA-METRICS
-+-+-+-
For information about CCD-world, send email to owner-CCD-world at cfht.hawaii.edu.